couturegerma.blogg.se

Refer to Vehicle Standard (Australian Design Rule Definitions and Vehicle Categories) 2005.Įvery vehicle except a ‘B-Double’ ‘ Prime Mover’ shall have a turning circle in either direction, as determined by reference to the extreme outer edge of the tyre track at ground level, not exceeding 25 metres in diameter.Ĥ3.4.0. Over 3.5 tonnes and up to 4.5 tonnes ‘GVM’Ĥ3.1.1. Up to 3.5 tonnes ‘GVM’ and more than 12 seats Up to 3.5 tonnes ‘ GVM’ and up to 12 seats Prior to the relevant date of effect, vehicles certified to ADR 43/02 must also be certified to ADR 61/00 "Vehicle Marking". Vehicles certified to any of the "Acceptable Prior Rules" as shown below in the Applicability Table for a particular vehicle category shall be deemed to comply with this Rule ** provided that "T-group" vehicles meet Clause 43.6.2.1. The Package 13 issue of /02 relaxes the ‘Load Sharing Suspension’ requirements (Section 43.7) and alters the maximum dimensions of ‘Semi-trailers’ (Section 43.4.1.2) (3) a Clause 43.4.0 has been added which permits ‘Approved’ variations to dimensions. (2) requirements for a ‘Semi-trailer’ with a sliding ‘Axle Group’ have been added. (1) the marking requirements have been transferred to a new ADR, 61/00 "Vehicle Marking" The /02 Rule differs from the /01 Rule in that: This ADR applies to the design and construction of vehicles as set out in the table hereunder. The function of this Australian Design Rule is to specify requirements for vehicle configuration and dimensions. This Australian Design Rule (ADR) is part of the Australian motor vehicle standards system and is a national standard for the purposes of the Motor Vehicle Standards Act 1989. This Standard also repeals each instrument made under section 7 of the Motor Vehicle Standards Act 1989 that creates a vehicle standard with the name Australian Design Rule 43/02 - Vehicle Configuration and Dimensions, if there are no other vehicle standards created by that instrument, or amendments to vehicle standards made by that instrument, that are still in force at the commencement of this Standard. (b) in force at the commencement of this Standard.Ġ.3.2. (a) made under section 7 of the Motor Vehicle Standards Act 1989 and

This Standard repeals each vehicle standard with the name Australian Design Rule 43/02 - Vehicle Configuration and Dimensions that is:

This Standard commences on the day after it is registered.Ġ.3.1.

This Standard may also be cited as Australian Design Rule 43/02 - Vehicle Configuration and Dimensions.Ġ.2.1. This Standard is the Vehicle Standard (Australian Design Rule 43/02 – Vehicle Configuration and Dimensions) 2006.Ġ.1.2.